Western blot analysis of extracts from NK-92, MOLT-4, and Raw 264.7 cells using ADAP Antibody.
Western blot analysis of extracts from 293T cells, mock transfected (-) or transfected with a construct expressing Myc/DDK-tagged full-length human ADAP (hADAP-Myc/DDK; +), using ADAP Antibody.
|MW (kDa)||120, 130|
Supplied in 10 mM sodium HEPES (pH 7.5), 150 mM NaCl, 100 µg/ml BSA and 50% glycerol. Store at –20°C. Do not aliquot the antibody.
For western blots, incubate membrane with diluted primary antibody in 5% w/v nonfat dry milk, 1X TBS, 0.1% Tween® 20 at 4°C with gentle shaking, overnight.
NOTE: Please refer to primary antibody datasheet or product webpage for recommended antibody dilution.
NOTE: Prepare solutions with reverse osmosis deionized (RODI) or equivalent grade water.
Load 20 µl onto SDS-PAGE gel (10 cm x 10 cm).
NOTE: Volumes are for 10 cm x 10 cm (100 cm2) of membrane; for different sized membranes, adjust volumes accordingly.
* Avoid repeated exposure to skin.
posted June 2005
revised November 2013
Reprobing of an existing membrane is a convenient means to immunoblot for multiple proteins independently when only a limited amount of sample is available. It should be noted that for the best possible results a fresh blot is always recommended. Reprobing can be a valuable method but with each reprobing of a blot there is potential for increased background signal. Additionally, it is recommended that you verify the removal of the first antibody complex prior to reprobing so that signal attributed to binding of the new antibody is not leftover signal from the first immunoblotting experiment. This can be done by re-exposing the blot to ECL reagents and making sure there is no signal prior to adding the next primary antibody.
NOTE: Prepare solutions with reverse osmosis deionized (RODI) or equivalently purified water.
posted June 2005
revised June 2016
Protocol Id: 263
ADAP Antibody recognizes endogenous levels of total ADAP protein.Species Reactivity:
Polyclonal antibodies are produced by immunizing animals with a synthetic peptide corresponding to residues surrounding Pro731 of human ADAP protein. Antibodies are purified by protein A and peptide affinity chromatography.
ADAP (adhesion and degranulation-promoting adaptor protein/SLAP-130/Fyb) is an SH3 domain-containing adaptor protein expressed by T cells, NK cells, and myeloid cells (1,2). There are two isoforms of ADAP with predicted molecular weights of 85 kDa and 90 kDa, but observed molecular weights of 120 kDa and 130 kDa (1-3). ADAP was identified as an adaptor protein that interacts with SLP-76 following T cell receptor (TCR) stimulation and was subsequently found to be important for several aspects of T cell activation (1,2). For example, ADAP is required for integrin-dependent clustering, signaling, and adhesion (4,5). In addition, ADAP interacts with CARMA1 and facilitates assembly of the CARMA1-Bcl10-MALT1 complex important for NF-κB activation downstream of TCR activation (6). Finally, following binding of a T cell to an antigen presenting cell, ADAP forms a ring at the immunological synapse that recruits dynein to enable microtubule-organizing center polarization (7).
Explore pathways + proteins related to this product.
Cell Signaling Technology is a trademark of Cell Signaling Technology, Inc.