Immunoprecipitation of PRAS40 from HeLa cells using PRAS40 (D23C7) XP® Rabbit mAb #2691 (lane 2). Lane 1 contains input control lysate. All lanes are probed with PRAS40 (D23C7) Rabbit mAb #2691 as the primary antibody. Secondary antibodies include Anti-rabbit IgG, HRP-linked Antibody #7074 (panel A) and Mouse Anti-rabbit IgG (Conformation Specific) (L27A9) mAb (HRP Conjugate) #5127 (panel B).
Immunoprecipitation of Beclin-1 from HeLa cells using Beclin-1 (D40C5) Rabbit mAb #3495 (lane 2). Lane 1 contains input control lysate. All lanes are probed with Beclin-1 (D40C5) Rabbit mAb #3495 as the primary antibody. Secondary antibodies include Anti-rabbit IgG, HRP-linked Antibody #7074 (panel A) and Mouse Anti-rabbit IgG (Conformation Specific) (L27A9) mAb (HRP Conjugate) #5127 (panel B).
Affinity purified mouse anti-rabbit IgG (Conformation Specific) HRP Conjugate antibody.
Recommended Antibody Dilution:
Supplied in 136 mM NaCl, 2.6 mM KCl, 12 mM sodium phosphate (pH 7.4) dibasic, 2 mg/ml BSA, and 50% glycerol. Store at –20°C. Do not aliquot the antibodies.
For western blots, incubate membrane with diluted primary antibody in 5% w/v BSA, 1X TBS, 0.1% Tween® 20 at 4°C with gentle shaking, overnight.
NOTE: Please refer to primary antibody product webpage for recommended antibody dilution.
From sample preparation to detection, the reagents you need for your Western Blot are now in one convenient kit: #12957 Western Blotting Application Solutions Kit
NOTE: Prepare solutions with reverse osmosis deionized (RODI) or equivalent grade water.
Load 20 µl onto SDS-PAGE gel (10 cm x 10 cm).
NOTE: Volumes are for 10 cm x 10 cm (100 cm2) of membrane; for different sized membranes, adjust volumes accordingly.
* Avoid repeated exposure to skin.
posted June 2005
revised June 2020
Protocol Id: 10
Mouse Anti-rabbit IgG (Conformation Specific) (L27A9) mAb (HRP Conjugate) recognizes the native rabbit IgG. This antiobdy may cross react with denatured [light chain] IgG at high concentrations.
Monoclonal antibody is produced by immunizing animals with native total rabbit IgG.
Mouse Anti-Rabbit IgG (Conformation Specific) (L27A9) mAb only reacts with native IgG and does not bind to the denatured and reduced rabbit IgG heavy chain or light chain. When performing immunopreciptiation (IP) followed by western blotting, the denatured rabbit IgG light and heavy chains of the primary antibody used for IP run at approximately 25 and 50 kD, respectively, on the subsequent western blot and can often obscure bands of proteins that have similar molecular weights. Using Mouse Anti-Rabbit IgG (Conformation Specific) (L27A9) mAb as a secondary antibody will eliminate this problem.
Except as otherwise expressly agreed in a writing signed by a legally authorized representative of CST, the following terms apply to Products provided by CST, its affiliates or its distributors. Any Customer's terms and conditions that are in addition to, or different from, those contained herein, unless separately accepted in writing by a legally authorized representative of CST, are rejected and are of no force or effect.
Products are labeled with For Research Use Only or a similar labeling statement and have not been approved, cleared, or licensed by the FDA or other regulatory foreign or domestic entity, for any purpose. Customer shall not use any Product for any diagnostic or therapeutic purpose, or otherwise in any manner that conflicts with its labeling statement. Products sold or licensed by CST are provided for Customer as the end-user and solely for research and development uses. Any use of Product for diagnostic, prophylactic or therapeutic purposes, or any purchase of Product for resale (alone or as a component) or other commercial purpose, requires a separate license from CST. Customer shall (a) not sell, license, loan, donate or otherwise transfer or make available any Product to any third party, whether alone or in combination with other materials, or use the Products to manufacture any commercial products, (b) not copy, modify, reverse engineer, decompile, disassemble or otherwise attempt to discover the underlying structure or technology of the Products, or use the Products for the purpose of developing any products or services that would compete with CST's products or services, (c) not alter or remove from the Products any trademarks, trade names, logos, patent or copyright notices or markings, (d) use the Products solely in accordance with CST's Product Terms of Sale and any applicable documentation, and (e) comply with any license, terms of service or similar agreement with respect to any third party products or services used by Customer in connection with the Products.